To Change The Template Type (Xj-Ut352W, Xj-F11X, Xj-F101W); To Change The Template Type (Network Models) - Casio XJ-UT312WN User Manual

4.
To stop template projection, change to another input source or turn off the
projector.
 If you turn off the projector while a template is being projected, the same template will be
projected again when you turn power back on.
Note
 Note that an image input signal being input to the projector cannot be projected while a
template is being projected.
 Auto Projection Off (page 43) and Auto Power Off (page 60) are both disabled while a template
is being projected.
 With an XJ-UT352W, XJ-F11X, and XJ-F101W model, the following settings cannot be
adjusted while a template is being projected: "Brightness" (page 56), "Contrast" (page 56).

To change the template type (XJ-UT352W, XJ-F11X, XJ-F101W)

1.
While a template is being projected, press the [FUNC] key and then the [ENTER]
key.
 This displays the "Template Type" menu.
2.
Use the [] and [] keys to select the template you want to project, and then
press the [ENTER] key.

To change the template type (Network Models)

1.
While a template is being projected, press the [FUNC] key and then the [ENTER]
key.
 This displays the template selection screen.
2.
Use the cursor keys to move the focus to the template you want to project.
 To project a template that is located in a folder that is different from the currently displayed
folder, perform the steps below.
(1) While the focus is located at any template on the far left, press the [] key.
 This moves the focus to the folder selection area.
(2) Use the [] and [] keys to move the focus to the folder that contains the template you
want to project.
(3) Press the [] key.
 This moves the focus back to the template selection area.
(4) Use the cursor keys to move the focus to the template you want to project.
3.
Press the [ENTER] key.
Note
 Under network model initial default settings, only the top folder contains templates. All of the
other folders are empty. For information about the procedure to add a template, refer to the
separate "Network Function Guide".
50