Changing The Input Source Manually; Relationship Between Image Input And Audio Input - Casio XJ-UT312WN User Manual

Changing the Input Source Manually

Use the procedure below to change the input source manually.
1.
Press the [INPUT] key to display the input menu.
2.
Use the [INPUT], [], and [] keys to select the name of the input source you
want, and then press the [ENTER] key.
 Note that even if you do not press the [ENTER] key, the projector will automatically switch to
the input source you selected after about three seconds.
 The name of the input source you selected will appear in the upper right corner of the
projection screen for a few seconds.
 The message "No signal input" will appear if an input source cannot be found.

Relationship Between Image Input and Audio Input

Selecting an input source causes the projector to output the image from the image input terminal that
corresponds to the input source, and the audio from the audio input terminal. The relationship
between input sources and terminals is shown in the table below.
Input Source
1
Computer (1/2)* COMPUTER IN (1/2)*
Video VIDEO
HDMI (1/2)* 1 HDMI (1/2)*
2
CASIO USB Tool* USB-A (1/2)*
2
Network* USB-A (1/2)*
Templates (Projects a projector built-in image.)
*1 The number of inputs (input terminals) depends on your projector model.
*2 Network models only
*3 YW-41 wireless adapter connection is required. See "Connecting a Wireless Adapter" (page 32).
Image Input Terminal (Fixed)
1
1
1
*
1 3
or LAN
Audio Input Terminal (Initial Default)
AUDIO IN (1/2)*
AUDIO IN R/L
HDMI (1/2)* 1
AUDIO IN 1 (May be AUDIO IN, depending on the
model.)
*
1 3
USB-A (1/2)*
AUDIO IN 1 (May be AUDIO IN, depending on the
model.)
41
1
or LAN (Network AUDIO)