Alcatel SPEED TOUCH 710 User Manual page 167

Adding specific routes
to the 'IP route' table
Criteria for a route to
be valid
3EC 17605 AAAA TCZZA Ed. 02
Proceed as follows:
1. Enter the following route information:
'Destination' IP address (pool) of the destination or
D
next hop" device in prefix notation
Specifying default indicates that all outgoing traffic is
sent over this route.
'Source' IP address (pool) in prefix notation
D
Specifying any indicates that all traffic coming from the
Ethernet interface is sent over this route.
'Gateway' IP address of a directly connected gateway
D
device, e.g. the AST710 itself.
2. Click . As a result the route is applied.
3. Click
permanent storage.
A route is only accepted by the AST710 if it meets following
conditions:
The destination and source entries must yield correct prefixes
"
The gateway must be directly connected.
"
to store the routing configuration to
13 Networking - IP
167 / 254