Alcatel SPEED TOUCH 710 User Manual page 147

'IP address' table
components
3EC 17605 AAAA TCZZA Ed. 02
Field Description
Intf Indicates the interface (Intf) to which the IP parameter set was
assigned to.
It can take several values depending on the packet services
that are active. The Ethernet (eth0) and the Loopback (loop)
are always present.
Address Shows the IP address of the interface.
Netmask If available, it shows the netmask of the interface.
Type Indicates the origin of the IP parameters.
It can take following values:
Value Description
Auto
User
Extra Implies that an additional IP parameter set
Temp Implies that this (additional) IP parameter
Transl Indicates whether address translation is performed on this IP
address or not.
It can take following values:
Value Description
None
PAT
Implies that the parameters were acquired
automatically through DHCP , or are typical
standard IP addresses (e.g. 'loop').
Implies that an additional IP parameter set
was added through the 'Initial Setup' page.
was added through the 'Routing' page. The
default IP address 10.0.0.138 is also of this
type.
set was added via a Ping of Life .
No address translation can be performed
on this address.
NA(P)T can be (or is) performed on this
address.
13 Networking - IP
147 / 254