Washer Help Codes; Dryer Help Codes - Maytag W10376697 Service Manual

WaSHer HelP CODeS

Help Codes
Help
Code
(Hex)
OF Oversuds detected during cycle, and washer was not able to resolve
an unbalance condition detected during the final spin related to the
oversuds detection (via pressure sensor) earlier in the cycle.
32 More than 4 unbalance retries during the final spin. Cycle has
been canceled.
33 Oversuds detected during wash cycle, and washer was not able to
resolve the condition – cycle has been aborted. Washer unable to
sense that water has been fully drained within required time, sensing
as an oversuds condition. F21 or F35 received from washer.
71 Generation 2 debit card cycle polling message out of sequence.
74 Generation 2 debit card remaining balance message out of sequence.
75 Generation 2 debit card new card balance message out of sequence.
88 Invalid messaging state found in data acquisition (DA) communication
comm_suprv ( ) routine.
Description

Dryer HelP CODeS

Help Codes
Help
Code
71 Generation 2 debit card cycle polling message out of sequence
74 Generation 2 debit card remaining balance message out of sequence
75 Generation 2 debit card new card balance message out of sequence
88 Invalid messaging state found in da communications comm_suprv ( ) routine
Help Mode Submenu
Display
Step Indication
1 1h.XX
2 2h.XX
3 3h.XX
4 1.X##
5 2.X##
6 3.X##
7 4.X##
8 SC.XX
9 SU.XX
10 EU .XX
* To erase the 3 help codes, press DELICATES button.
** The Errors displayed in this section are the history errors that have occurred in the dryer (not
necessarily an error that is in progress). The current error is displayed in the MANUAL KEY
FUNCTION IN DIAGNOSTIC SUB-MODE.
6-11
Description
Explanation
Help Code 1, where XX is the help code
number. *
Help Code 2, where XX is the help code
number. *
Help Code 3, where XX is the help code
number. *
Error history code 1, where X is the F or d
code, and ## is the code number. **
Error history code 2, where X is the F or d
code, and ## is the code number. **
Error history code 3, where X is the F or d
code, and ## is the code number. **
Error history code 4, where X is the F or d
code, and ## is the code number. **
CCU software revision, where XX is the
software revision number.
UI software revision, where XX is the
software number.
UI EEPROM revision, where XX is the
EEPROM number.