Installation And Commissioning; Installing Falcon Mj M-Bus; Connection; Configuration With Mbconf - Honeywell FALCON MJ Pulse/M-Bus Operating Instructions Manual

2

Installation and commissioning

2.1

Installing Falcon MJ M-Bus

Refer to the separate installation instructions inside the package.
2.2

Connection

The Falcon MJ will be delivered with a permanently attached 5 wires cable, 3m length. The
yellow and green M-Bus wires can be connected with e.g. suitable distribution terminal strips.
The polarity of the M-Bus wires is irrelevant.
3

Configuration with MBCONF

This device's configuration must be adapted by the customer to the given meter. This can be
done, for example, with the program MBCONF, version 3.6 and higher, which will be described
below.
3.1

Installation

The MBCONF parameterization software for the Falcon MJ is a 32-bit application that can be
executed on an IBM compatible PC running a Windows 95 / 98 / XP / 7 / 10 operating system.
The desktop or laptop PC to be used must have a free USB interface connection. This interface
connection must be connected to an M-Bus level converter (MR003 USB / MikroMaster).
The Falcon MJ device which I configured must have a 1:1 connection (i.e. be the only M-Bus
device attached) to the M-Bus output of the level converter.
In order to install the software onto the PC, please execute the file
"MBCONF_SETUP.EXE" by selecting it from the Windows Explorer or via "Start – Run". The
setup program allows selection of a language during installation. If desired, a program group
and a desktop link can be created. Both language variations, German and English, can
thereafter be selected for execution from the Start menu or directly from the desktop link.
Falcon MJ M-Bus Operating instructions
05/18 Generation 1.2 Page 3 of 38