Honeywell FALCON MJ Pulse/M-Bus Operating Instructions Manual page 9

Maximum Flow rate
displays the max flow rate registered by the module with the
according date.
The date will only be shown if the module is connected to the
M-Bus permanent. For quick read out via MBConf, use the
"Historical values" button to see the last monthly values and also
the last monthly max. flow values.
Erase hist. values
deletes all monthly values in the Falcon MJ module. I.e. historic monthly meter
index and historic max. flow rate values.
Historical values
displays all Falcon MJ stored monthly values in a pop-up window. This control
button is only active when the "Long telegram" radio button is active. This
control will also store values for maximum throughput of the day and the
month.
Read clock of PC
reads the PC system's current date and time and enters this data into the
"Current time" field.
Due-date cnt.
is the stored meter counter index for the Due date. This field cannot be edited
(read only).
Due-date
is the last reporting date (i.e. date when the meter index was stored the last
time) in the format DD.MM.YY. This field cannot be edited (read only).
Next due-date
is the next due date (i.e. date for the next storage of meter index) in the format
DD.MM.YY. Storing will take place at 00:00 on the due date, e.g. if next
reporting day is 01.01. then following a change from 31.12. 23:59 to 01.01. at
00:00. The field can only be edited when the check-box "Edit time" is activated.
ExtendedSettings / Warnings
opens a new tab card responsible for the configuration of alarms, pulse
outputs settings and other information (see section 3.4).
M-Bus telegram settings
displays the setting for telegram type effective for the Falcon MJ.
Falcon MJ M-Bus Operating instructions
05/18 Generation 1.2 Page 9 of 38