Cisco MDS 9000 Series Configuration Manual page 307

Configuring Port Tracking
Displays a Tracked Port Configuration for a PortChannel Interface
switch# show interface port-channel 1
port-channel 1 is down (No operational members)
Hardware is Fibre Channel
Port WWN is 24:01:00:05:30:00:0d:de
Admin port mode is auto, trunk mode is on
Port vsan is 2
Linked to 1 port(s)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
No members
Displays a Forced Shutdown Configuration
switch# show interface fc 1/5
fc1/5 is up
Hardware is Fibre Channel, FCOT is short wave laser
Port WWN is 20:05:00:05:30:00:47:9e
Admin port mode is F
Port mode is F, FCID is 0x710005
Port vsan is 1
Speed is 1 Gbps
Transmit B2B Credit is 64
Receive B2B Credit is 16
Receive data field Size is 2112
Beacon is turned off
Port track mode is force_shut <--this port remains shut even if the tracked port is
back up
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
0 receive B2B credit remaining
0 transmit B2B credit remaining
Port linked to interface fc1/1
0 frames input, 0 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
0 frames output, 0 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Verifying Port Tracking Configuration
289