Overview The Moxa NPort S8000 series fully integrates an industrial serial device server and redundant managed Ethernet switch into a single device, making it easy to enable your serial devices to operate over a network and connect Ethernet-enabled devices in industrial field applications.
LED Indicators—The NPort S8000’s front panel contains some LED indicators as described in the following table. Type Color Meaning PW 1 Green Power 1 input PW 2 Green Power 2 input Ready Steady On: Power is on, and the NPort is booting up.
Page 4
Wall Mounting (optional) In high-vibration environments, we suggest using the NPort S8000’s wall-mount kit to fix. The installation procedure is described below: STEP 1: Remove the aluminum DIN-rail attachment plate from the NPort S8000’s rear panel and then attach the wall-mount plates with M3 screws.
Turbo Ring DIP Switch Settings The default setting for each DIP switch is OFF. The following table explains the effect of setting the DIP switch to the ON position. Turbo Ring Settings DIP 1 DIP 2 DIP 3 DIP 4 –...
Page 6
Wiring the Relay Contact The NPort S8000 has two sets of relay outputs: relay 1 and relay 2. Each relay contact consists of two contacts of the terminal block on the NPort S8000’s top panel. Refer to the next section for detailed instructions on how to connect the wires to the terminal block connector and how to attach the terminal block connector to the terminal block receptor.