Adjusting Swivel Axles; Seat Depth - Vermeiren V300 30 Installation Manual

3.3.3 Adjusting swivel axles

Verify that the swivel axle (F) stands perpendicular to the ground. If not, adjust the swivel
axle at toothed clamp (G) as follows:
1. Loosen the three socket screws (15).
2. Adjust the angle of the swivel axle until it is perpendicular to the ground. There are 5
positions available, each indicated by a small triangle.
3. Tighten the 3 socket screws (15) firmly and repeat this for the second swivel axle.
F
A
3.4

Seat depth

The procedure of this adjustment is explained in §3.4.1.
The adjustment settings depend on the wheelchair model as collected in the tables in section
§3.4.2, §3.4.3 and §3.4.4. Each table is followed by an illustration of the adjustment points.
Important remark
When adjusting the backrest connection, make sure
that all 3 connection screws (item 59, in example) are
tightened firmly.
To prevent that theft-protection systems in shops
react on the wheelchair frame, the connection
screws (59) must be turned through the frame
coating!
15
Installation manual
- 9 -
V-series wheelchairs
2018-10
Adjustments
G
59
59
59
View from the inside
EN
NL
PL
CS