Nexxt Acrux3000 User Manual page 12

Nexxt Solutions - ACRUX - Wireless N Gigabit Router
The router's LEDs and the WPS button are located
on the front panel. (Viewed from left to right).
Name Status
Off Power is off
Power
On Power is on
On Router is initializing or there may be a system error
System
Flashing Router is working properly
Off Router has a system error
Off The wireless function is disabled
WLAN
Flashing The wireless function is enabled
Off There is no device linked to the corresponding port
WAN, There is a device linked to the corresponding port,
On
but no activity is detected
LAN 1-4
Flashing There is an active device linked to the corresponding port
A wireless device is connecting to the network by WPS function.
Slow Flash
This process will takes 2 minutes to complete
A wireless device has been successfully added to the
WPS On
network by WPS function
A wireless device failed to be added to the network
Quick Flash
by WPS function
Table 1-1 LEDs description
Note:
After a device is successfully added to the network
by WPS function, the WPS LED will remain
illuminated for about 5 minutes before going off.
1.4.2 Rear panel
Figure 1-2 Rear Panel sketch
Indication
12