Johnson AFG Pro 7.2AT Service Manual page 29

4.6 RUNN NING BELT
1) Remove the motor co
2) Remove the rear rolle
3) Remove the running
4) Remove the front roll
5) Remove the running
6) Reverse e Steps 1-5 t
Note1:
1. Adjust t running belt
2. The run nning deck is
belt.
Note:2
ADJUSTING G THE RUN
After plac cing the tread
centering. T The belt may
cause the b belt to stretch
direction be elow.
Step1: Loca ate the two h
frame at the e back of trea
prevent ove er tightening
Step2: The belt should h
do not start the treadmil
center the b belt by pushin
loosened th hem, approxi
Step3: Whil e the treadm
Right bolt by y turning it cl
left tighten t the left bolt b
remains cen ntered for se
Step4: Chec ck the tensio
should not h hesitate or sl
necessary.
CHA APTER 4:
T REPLAC CEMENT
over as outlin ned in Sectio
er as outlined d in Section 4
deck as outl ined in Secti
er as outline ed in Section
belt
to install a ru unning belt. (
t tension afte er replaceme
s silicon on o ne side . New
NING BELT T
dmill in the p osition it will
need to be a adjusted afte
h at different rates. If the
ex head bolt t on the rear
admill. These e bolts adjust
of one side.
have equal d istance on e
l. Turn the b olts counter
ng the belt fr rom side to s
mately one f full turn. Insp
mill is running g at 3 mph, o
lockwise 1/4 turns, and lo
by turning it c lockwise 1/4
everal minute es.
on of the belt . The belt sh
lip. If this occ curs, tighten
Part Rep placement
on 4.1.
4.2.
on 4.4.
4.5.
F Fig-1
(Fig-1 & Fig-2 2)
ent (Note2)
w deck surfa aces must AL
be used, the e belt must b
er the first 2 h hours of use
belt starts to o slip when a
of the treadm mill. The bolt
t the rear roll ler. Do not ad
either side be etween the fra
clockwise ap pproximately
side. Tighten the bolts the
pect the belt f for damage.
observe the b belt position.
oosen the lef ft bolt 1/4 turn
4 turn and loo osen the righ
hould be very y snug. When
the belt by t urning both b
Guide
LWAYS be m matched to a
be checked fo or proper ten
. Temperatur re and humid
user is on it , be sure to f
ts are located d at each en
djust until the e treadmill is
ames. If the b belt is touchi
y one full turn n on each sid
e same amou unt as when
If it is movin ng to the righ
n. If it is mov ving to the lef
t 1/4 turn. Re epeat step 3
n a person w walks or run o
bolts clockwi ise 1/4 turn,
Fig-2
new running g
nsion and
dity, and use e
follow the
d of the
s on. This will l
ing one side, ,
de. Manually
the user
t, tighten the e
ft, tighten the e
until the belt t
on the belt, it t
Repeat if
29 9