3.3.4 TROUBLESHOOTING - INCLINE MOTOR ISSUES
SOLUTION:
a. Press the "INCLINE" keys, the console should beep and display incline change, if no, replace the
.
key pad
b. Enter Engineering Mode, and scroll to ENG 1 (Hardware Test). Press the "ENTER" key
first and then the "START" key.
c. Press the "INCLINE
If can hear clicks
elevation motor at the MCB first, try to unplug and re-plug. If this does not resolve the issue,
replace the elevation motor.
If there are no clicks from these two relays, MCB is defective and replace the MCB.
CHAPTER 3: Troubleshooting
▲/▼"
key.
from two relays at the MCB, the MCB is ok. Then check the connection of the
19