Changing The Signal Name - Furuno MU-120C Operator's Manual

3.3.2

Changing the signal name

You can change the signal name which is shown on the DISP or PIP menu, described in the
next chapter. It is useful to use the name of the device connected (ex. "FCV-1200L"). For
detailed information about these menus, see Chapter 4.
1. Press the [MENU] key to show the main menu.
2. Press the [►] key to choose the OSD menu.
RGB1 RGB2 DVI VIDEO1 VIDE02 VIDE03
H_POSITION
V_POSITION
TRANSLUCENT
CUSTOM NAME
RGB1
RGB2
DVI
VIDEO1 = VIDEO1____
VIDEO2 = VIDEO2____
VIDEO3 = VIDEO3____
3. Press the [▲] or [▼] key to select the signal to change its name in CUSTOM NAME
area. In the example above, RGB1 is chosen.
4. Press the [►] key to select the character you want to change. In the example below, "G"
is selected.
5. Press the [▲] or [▼] key to select appropriate alphanumeric character. In the example
below, "5" is selected.
6. To change another signal name, press [◄] and then press [▲] or [▼] to select it.
= RGB1______
= RGB2______
= DVI_______
OSD menu
CUSTOM NAME
RGB1 = ______
RGB1 = ______
RGB2 = ______
RGB2 = ______
DVI = ______
DVI = ______
CUSTOM NAME
RGB1 = ______
R5B1 = ______
RGB2 = ______
RGB2 = ______
DVI = ______
DVI = ______
11
25 (1 - 50)
21 (1- 50)
OFF (ON/OFF)
OSD