Yetter 2968-026 Set-Up / Parts Manual page 18

STEP 7:
Install each P-Clip to the Formed Hose Holder using ¼" X ½" bolts, ¼" lock washers, & ¼" hex nuts. A
P-Clip should be placed on the side with blade for single wheel placement & on both sides for dual wheel
placement.
SINGLE WHEEL
STEP 8:
Install each Injector Holder behind each blade. Thread a 3/8" hex jam nut on the threaded rod roughly 2",
place a 3/8" lock washer & 3/8" flat washer over the threaded rod against the hex jam nut. Slide the
threaded rod through the horizontal slotted hole on the fertilizer wheel mount so that the threaded rod
end is on the outside of the fertilizer wheel mount. Place a 3/8" flat washer over the end & thread another
3/8" hex jam nut. Before tightening, center the coupler behind the blade & point the bottom of the
coupler slightly forward. Install the push connect fitting on the top side of the coupler if you wish to use it.
INSTALLATION INSTRUCTIONS
DUAL WHEEL
18