Getting Started; Installing The Batteries - C. Crane CC Skywave SSB Instruction Manual

Getting Started

Installing the Batteries

1. Position the radio face down on a soft surface to protect it.
2. Remove the battery cover by applying pressure and sliding downwards towards the
bottom of the radio.
3. Insert the two (2) "AA" alkaline or NiMH cell batteries into the compartment as indicated.
Be sure the negative (-) end of each battery is against the spring.
4. Replace the battery cover. You are now ready to operate your radio.
Two (2) "AA" alkaline or NiMH batteries.
DO NOTUSE LITHIUM BATTERIES.
NOTE: You will have 30 seconds after batteries
are removed before the clock and alarm
settings are lost. We recommend having your
new batteries ready to insert immediately after
removing the old ones.
In our test, (going slowly) it took us about 15
seconds to add the new batteries after
removing the old ones. The memory presets
and other settings are stored in permanent
memory so they will not be lost if the radio is
unpowered for a duration of time.
Page 6