Getting Started; Turning The Radio On; Scanning For Wireless Networks - C. Crane CCWiFi Instruction Manual

Getting Started – Turning On Your WiFi Radio
Note: Configuring a WiFi radio is similar to navigating through a cell
phone menu.
Plug the power adapter cube into a 120V AC power outlet. Connect
the power adapters small plug into the jack on the back of the radio
that is labeled "DC IN 7.5V".
Caution: Use only the power adapter supplied with the radio.
Connecting a power adapter other than the one that was sup-
plied with your radio could cause permanent damage to the
After a few seconds the display on the front of the radio will light up
radio and may be hazardous.
and show:
Followed by:
Followed by:
Starting ...
Followed by:

Scanning for Wireless Networks

When <Scan for Networks> is displayed, press "SELECT" by press-
ing "in" the main dial (the main dial should click when pressed in).
The display will show:
Page 6
CC WiFi Radio
Reciva Enabled
ARM Powered
and
<
Scan for Networks
Enter Network
Initialising
Network
>
CC WiFi