Advertisement
6.
For the K8032 Torque Wrench, place your thumb on the Thumb Grip (4A) located on the
outside edge of the Torque Scale (3) and gently grasp the handle ball (4B). Slowly and evenly pull
the handle until you hear the click or see the Indicator Pin (5) release. The set torque has been
achieved.
SPARE PARTS
K8030 Spare Parts
1.
K8030-1
2.
K8030-2
3.
K8030-3
K8031 Spare Parts
1.
K8031-1
2.
K8031-2
3.
K8031-3
CARE AND MAINTENANCE
It is normal for torque wrenches to go out of calibration with time and regular use. Whatever type of torque
wrench you are using, regular calibration will ensure that your tools remain as accurate and effective as
possible.
Putting in place a regular schedule for verifying and calibrating your torque wrench will mean less room
for error. Kincrome Tools and Equipment recommend you have your torque wrench calibrated by a NATA™
approved calibration facility, every 12 months or 1,000 cycles. If your Kincrome Torque Wrench is dropped,
knocked, even in the protective blow mould case, or any part replaced, the wrench must be immediately
re-calibrated prior to next use. Your new Kincrome Torque Wrench is calibrated at the factory in Taiwan,
prior to shipping and a certificate of that calibration is supplied for your individually serialised torque
wrench. It is the sole responsibility of the owner/user of this tool to ensure the calibration is correct as the
Torque Wrench may have gone out of calibration during transit to retailers. For peace of mind, you should
get your torque wrench checked prior to first use. Please note, the Kincrome Limited lifetime warranty does
not cover the cost of calibration, or the removable square drive of the wrench.
WARRANTY
Warranty given by Kincrome Tools & Equipment Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby,
Victoria, Australia (Tel +61 3 9730 7100) If this product has materials or workmanship defects (other than
defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of
purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement.
Your rights under this warranty are in addition to any other rights you have under the Australian, United
Kingdom & Ireland Consumer Law or other applicable laws. Our goods come withguarantees that cannot
be excluded under the Australian, United Kingdom & Ireland Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure. For further details please visit www.kincrome.
com.au or call us. Due to minor changes in design or manufacture, the product you purchase may
sometimes differ from the one shown on the packaging.
DEFLECTING BEAM TORQUE WRENCH
Trip Kit
Wedge Assembly Kit
1/2" Square Drive
Trip Kit
Wedge Assembly Kit
3/8" Square Drive
K8032 Spare Parts
1.
K8032-1
2.
K8032-2
3.
K8032-3
K8034 Spare Parts
1.
K8034-1
2.
K8034-2
3.
K8034-3
Trip Kit
Wedge Assembly Kit
1/4" Square Drive
Trip Kit
Wedge Assembly Kit
3/4" Square Drive
4
Advertisement
