Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for kincrome K12091
Summary of Contents for kincrome K12091
- Page 1 HYDRAULIC SHOP PRESS Distributed by Kincrome Group www.kincromegroup.com...
-
Page 2: Table Of Contents
Using the Press........................5 Warning..........................5 MAINTENANCE AND STORAGE...................6 Important Note: ........................6 Adding Oil:...........................6 Replacing Oil:........................6 Cleaning ..........................6 Storage..........................6 Repairing Press........................6 SPECIFICATIONS Working Load limit 12000 KG Working range 0-710 mm Working width 400 mm Total Weight: 44 KG Part Number K12091... -
Page 3: Important Safety Information
IMPORTANT SAFETY INFORMATION The use of a Hydraulic Press has inherent dangers to avoid risk of personal injury or property damage make sure you are fully aware of the operating instructions for this product, the recommendations in this manual can not cover all eventualities this press is designed and intended for use by properly trained and experienced personnel. -
Page 4: Handle - Handle Wrench
height to ensure the plate is parallel. Handle - Handle Wrench With the jack sitting on the jacking plate place the jack handle wrench over release valve. Turn handle slowly clockwise until firm DO NOT over tighten. Remove handle from release valve and slide handle into handle base on jack. -
Page 5: Operating Press
OPERATING PRESS Preparing Work Area Before using the press, it is important to prepare work area properly. Follow this procedure each time the press is used to help prevent property damage and or serious injury. 1.) Thoroughly inspect press for damage or wear before each use. Briefly test operation of unloaded jack before using to press any job. -
Page 6: Maintenance And Storage
Do not move the press wherever practical the press should be bolted to the ground. Never place any part of your body through the frame or under any of the moving parts. The forces applied by this press are large if the arbor plates, press plate or jack plate are not parallel excessive forces can be generated which may lead to property damage or personal injury. - Page 7 DESCRIPTION DESCRIPTION 1 CROSS BEAM 10 LEGS 2 PRESS FRAME 11 BOLT (PRE-ASSEMBLED) 3 JACK PLATE 12 WASHER (PRE-ASSEMBLED ) 4 ARBOR PLATES 13 NUT (PRE-ASSEMBLED) 5 PRESS PLATE 14 RETURN SPRINGS 6 LEG SUPPORTS 15 HYDRAULIC JACK 7 BOLTS 16 RELEASE VALVE 8 WASHER 17 PINS...
- Page 8 Distributed by Kincrome Group www.kincromegroup.com 3 Lakeview Drive Scoresby Victoria...
- Page 9 Phone: 1300 657 528...