Page 3
Assembly The only assembly required for the Kincrome S.G Drill Press Vices is the assembly of the handle. Unscrew one of the end caps located on the spindle handle.
Keep machined surfaces and all moving parts clean and free of dirt, chips, and foreign materials. Use multipurpose grease to keep moving parts lubricated. Routinely apply mineral oil to machined surfaces to prevent surface rust. Spare Parts List K15050 K15051 K15052 K15050-1...
(Tel +61 3 9730 7100) If this product has materials or workmanship defects (other than defects caused by abnormal or non warrant- ed use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes ad- dresses for repair or replacement.