Page 1
10T HYDRAULIC BODY REPAIR KIT 10T HYDRAULIC BODY REPAIR KIT RATED QUICK FIT CAPACITY ACCESSORIES Caution: Do not allow persons to operate or assemble this jack until they have read this manual K15147 and developed a thorough understanding on how the jack works...
Give your work undivided attention. Looking around, carrying on a conversation, and “horse-play” are careless acts that can result in serious injury. Keep visitors a safe distance from the work area. Use recommended genuine Kincrome accessories. Improper accessories may be hazardous. Keep children and unauthorized persons away from the work area. Personal Safety Stay alert.
10T HYDRAULIC BODY REPAIR KIT Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations. Use safety equipment. A dust mask, non-skid safety shoes and a hard hat must be used for the applicable conditions. Always wear eye protection.
Close the release valve clockwise until tight (DO NOT over-tighten) (Fig 7). If the body repair kit does not feel like it is operating correctly, repeat the above process until all air has been purged from the system. If the problem continues contact Kincrome Customer Service. Fig.5 Fig.6...
With ram fully lowered, remove the oil filler screw and drain the oil into a suitable container. Ensure that no dirt gets into the system. Set the pump in its normal level position, fill with K12400 Kincrome Hydraulic Jack Oil, then replace the oil filler screw. Note: Dispose of hydraulic oil in accordance with local regulations.
Page 7
10T HYDRAULIC BODY REPAIR KIT When equipment efficiency drops, purge air from the hydraulic system: turn the release counter-clockwise by 1-1/2 turns, with ram fully retracted and release valve open, pump the handle rapidly 10 to 20 times. It is recommended that an annual inspection be performed by a qualified technician. Assembly Combinations Vertical Push Horizontal Push...
(2 years) commences on the date that the product is purchased. If this product has materials or workmanship defects (other than defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement.