6
Loosen the fixing screws (4 pieces) of the outdoor motor and remove the outdoor motor.
Notes on assembly: When assembling the propeller fan and outdoor motor, the alignment mark located in
the center part of the propeller fan should be aligned with the slit in the shaft of the outdoor motor.
16.2.6 Removing the Outer Side Panel (Right)
1
Perform "16.2.1 Removing the Outer Top Panel and Outer Front Panel".
2
Perform "16.2.2 Removing the Electrical Component Covers (2 & 3-way valve Cover and Terminal Plate
Cover)".
3
Disconnect the connector of the indoor/outdoor connection wires (red, white and black) and remove the fixing
screw of the earth wire (green).
4
Remove the screw (1 piece) which fixes the power-supply box to the outer side panel (right).
107