Panasonic CS-VE9NKE Service Manual page 39

16.1.7 Removing the Human and Object Sensor of the Control Board (Indicator and
Signal Receptor)
1 Perform "16.1.1 Removing the Front Panel".
2 Perform "16.1.3 Removing the Front Grille (Right) and Front Grille (Left)".
3 Disengage the tabs (2 locations) on both sides of the indicator panel. Then, remove the indicator panel.
4 Flip the indicator panel and remove the screws (2 pieces).

How to remove the human and object sensor
1 Disconnect the connectors (2 locations) for the control board (signal receptor).
2 Remove the fixing screw (1 piece) of the human and object sensor. Then, remove the human and object
sensor.
3 Remove the electrical component cover (front) on the right side of the control board box. (There are two tabs
on top and one tab at the bottom.)
94