Axminster Bandsaw Original Instructions Manual page 37

Code: 101807
INTRODUCTION
• Bandsaw Buddy is a unique bandsaw blade aligning tool.
Bandsaw Buddy allows you to check the alignment of the
bandsaw blade to the face of the fence. Most other checks
only require the use of a combination or engineer's square.
Truing the fence to the blade is tricky. Bandsaw Buddy has
two rare earth magnets which hold it firmly on the blade. At
250mm long it is easy to spot any discrepancy and then make
necessary adjustments. The magnets will keep it safely stored
on the bandsaw's frame when not in use.
• A scale on the tip helps set the bandsaw fence for cutting
veneers or thin boards. Holes along the Buddy's length at
12.5mm intervals allow you to draw arcs or circles in 25mm
steps from 75mm to 400mm, a useful feature for marking
curves or when cutting bowl blanks. Accurately machined
from anodised aluminium, it also makes a handy straight edge.
Marking Gauge
An easy to use circle marking
gauge for bowl blanks from
75mm to 400mm radius in
increments of 25mm.
Accurate Marking
The bandsaw buddy can be used
as a straight edge for accurate
marking.
UJK Technology Bandsaw Buddy
KEY FEATURES
• Designed and made in Axminster
• Unique bandsaw blade aligning tool
• Checks the alignment of blade to the face of the fence
• Rare earth magnets hold it firmly on the blade
• 250mm long makes it easy to spot any discrepancy
• Scale on the tip helps set fence for cutting veneers or thin
boards
• Holes for drawing circles in 25mm steps from 75 to 400mm
• Accurately machined from anodised aluminium
Thickness Gauge
A convenient and accurate
metric thickness gauge, great
for veneering.
37
Perfect Alignment
Rare earth magnets securely hold
the rule to the blade. This enables
you to align your rip fence and
table perfectly parallel with the
blade.
Keep your buddy on hand
Once you've used your Bandsaw
Buddy the integrated magnets
allow simple storage on your
bandsaw