Axminster Bandsaw Original Instructions Manual page 10

Main Assembly
Step 4 Locate the fence (3), M8 lift and shift handle/ M8
large washer (6) and threaded 'T' slot insert (7). Place the large
washer over the thread of the lift and shift handle (6), introduce
the handle through the machined hole to the side of the cast
iron mounting on the clamping assembly (4) and lightly screw
on the threaded 'T' slot insert (7), see fig 21.
Fig 21
6
Step 5 Introduce the 'T' slot to the side of the fence (3) over the
threaded 'T' slot insert (7) and slide on the fence until the fence
(3) is flush with the rear of the cast iron table (1). Tighten the lift
and shift handle (6) to secure the fence in position, see fig 22-23.
Fig 22-23
Spanner
7
'T' slot
3
NOTE: The fence (3) has two positions, vertical and
horizontal for cutting narrow pieces, see fig 24-25-26.
10
Fig 24-25-26