Axminster Bandsaw Original Instructions Manual page 29

The compact mitre fence head features positive stops at 0°,
22.5°, 30°, 45°, 60°, 67.5° and 90°, both left and right. This gives
you 13 preset common angles in total. The clear easily read
scale allows you to set the head to any intermediate angle. To
select an angle you simply loosen the clamp handle and lift
the indent plunger. Move the fence along until the plunger
seats itself in the indent corresponding to the angle required.
Re-tighten the angle clamp knob and carry on with the job.
Indent plunger locked down
Indent plunger Unlocked
Mitre gauge pointer
Flip-up length stop
Clamping handle
Length stop clamping knob
The bar is 320mm long with a removable locking washer
making it usable with any standard 19 x 9.5mm (3/4" x 3/8")
track or similar sized T-slot. Three sprung loaded ball bearings
keep the bar snug in the track; the fence runs true without
side-play.
The rugged 300mm long, 60mm high aluminium fence comes
complete with flip-up length stop.
Preset holes
Adjustable grub screw
Adjustable grub screw
29
Compact Mitre Fence
Fence clamping knobs
Mitre fence
Sprung loaded ball bearing