Chapter 5 Installing Hardware; Installing The Chassis; Installing In A Standard Cabinet; Installing On A Workbench - 3Com Switch 7700 Installation Manual

Hide thumbs Also See for Switch 7700:

Table of Contents

Chapter 5 Installing Hardware

This chapter describes how to install the components of the Switch 7700.

You can install the Switch 7700 in a standard, 19-inch cabinet or on a workbench.

Before you install the Switch 7700 in a standard cabinet, verify that:

1. Have two people carry the switch to the front of the cabinet.

2. Put the switch on the tray or the guides and push it into the cabinet.

3. Fix the switch in the cabinet with the combination screw and floating nuts that are shipped with the

delivery accessories.

Before you install the Switch 7700 on a workbench, verify that:

1. Have two people carry the switch at both sides to the place in front of the workbench.

2. Carry the switch a little higher than the workbench and lower it onto the workbench gently.

To install a module:

1. Wear an anti-static wrist strap

2. Remove the blank filler panel from the chassis slot and save it for future use

3. Hold the ejector levers of the module with both hands and push them outward

4. Align the module with the guides in the chassis and slide it gently into the slot

5. Push the module until the positioning pin on its handle bar touches the hole in the chassis

6. Push the ejector levers inward and push the handle bar pin into the positioning hole in the chassis

The cabinet has been well built

The installation position for the switch has been well arranged

There are no obstacles

The switch is ready for installation and has been carried to a place near the cabinet

The workbench is firm enough to hold the switch and cables

There are no obstacles around the workbench

The switch is ready for installation and has been carried to a place near the workbench

Table of Contents