Table of Contents
Advertisement
Overview
Introduction
This chapter covers the installation of PathBuilder S21x switch hardware.
Follow These Steps This table lists the steps you need to perform and shows you where to look for
information on installing the PathBuilder S21x switch:
Warning
The following special notices apply to all equipment handling procedures in this
manual.
Warning
Ports capable of connecting to ports on other apparatus are defined as Safety Extra
Low Voltage (SELV). To conform with EN60950, ensure that these ports are only
connected to ports of the same type on other apparatus.
Avertissement
Les ports qui sont susceptibles d'être connectés à des équipements sont désignés
comme TBTS. Pour garantir la conformité à la norme EN 60950, n'interconnecte
ces ports qu'avec des ports du même type sur des autres matériels.
Warnung
Anschlusse, die mit anderen Geraten verbindet werden konnen, sind als SELV
beschrieben. Um Konformitat mit EN 60950 zu versichern, sichern Sie es, daß diese
Anschlusse nur mit den des selben Type auf anderen Geraten verbindet werden.
Installing the PathBuilder S21x Switch Hardware
All manuals and user guides at all-guides.com
Installing the PathBuilder S21x Switch Hardware
Step
To Perform This Action
1
Check the contents of the
shipping package to make sure
everything is included.
2
Choose a site for the Path-
Builder S21x switch.
3
Connect cables for the Path-
Builder S21x switch.
4
Set the front panel dip switches
if required.
5
Installing Optional Daughter-
card.
6
Installing or Removing the Lith-
ium Battery
Chapter 2
See This Procedure
"Checking Your Shipment Contents"
section on page 2-2.
"Choosing a Site" section on page 2-3.
"Cabling the PathBuilder S21x Switch"
section on page 2-5.
"Front Panel Dip Switches" section on
page 2-10
"Installing Optional Daughtercards"
section on page 2-11
"Installing or Removing the Lithium
Battery" section on page 2-12
2-1
Advertisement
Table of Contents
