Switch-On Lock-Out Function - Rotex Solaris RPS3 P2 Operating And Installation Manual

Pressurised solar system
Table of Contents

Advertisement

The pumps are switch off when:
– The temperature difference falls below the value set at parameter "Delta T off" (e.g. return temperature = 45 °C and
– If the maximum storage tank temperature set in parameter "T
– If the maximum solar panel temperature set in parameter "T
T
OFF
T
ON
P
S1
P
S2
t
T
K
T
R
T
V
Zeit
PsA
Zeit
PsE
Zeit
UB
Fig. 5-2

5.2.2 Switch-on lock-out function

The switch-on lock-out function prevents:
– reactivation if the solar system has been automatically shutdown because the set maximum storage tank temperature
"T
– pump operation if the solar panel temperature exceeds the value set by the heating expert with the parameter "T
Under sustained solar radiation temperatures over 100 °C may occur at the solar panels after switching off the pumps. If the
storage tank temperature falls below the release temperature ("T
the pumps are switched on again when the cut-in switch protection temperature at the solar panels set with parameter "T
falls by 2 K. The T
The lock-out time "Time SP" function allows the pumps to be released again in a shutdown condition caused by the feed sensor
(FlowSensor) only after expiry of the lock-out time set in the Solaris R3P control system (0 – 600 s).
Therefore:
– cycling of the system can be minimised.
– the solar panels can reach a higher temperature.
– the feed temperature during filling the system does not fall below the cut-out condition and the system regulates itself faster.
FA ROTEX Solaris RPS3 P2 - 06/2012
"Delta T off" = 2 K; Solaris feed temperature <47 °C).
pumps can only be started again if the storage tank temperature has fallen by more than 2 K.
can only be started again if the solar panel temperature has fallen by more than 2 K.
If a FlowSensor is not installed or is faulty, the P1 tank circulation pump runs constantly at the set output level
(without speed control). The pumps are regulated exclusively by the temperature difference between the solar
panel and Solaris return flow temperature.
Switch-on temperature difference
Switch-on temperature difference
Tank circulation pump
Solar panel circulation pump
Time
Collector temperature
Return flow temperature
Flow temperature
Tank circulation pump cut-out delay
Tank circulation pump cut-in delay
Reverse condition delay time
Start sequence for storage tank and solar panel circulation pump
max" has been reached.
S
indicator flashes.
K
max" is reached (T
S
S
zul" is reached (T
indicator flashes). In this case the pumps
k
k
1
Tank circulation pump cut-in delay:
For maximum use of the heat the solar panel circuit is started before
circulating the storage tank circuit. The preheated plate heat
exchanger can heat immediately with the time-offset start of the tank
circulation pump.
2
Tank circulation pump cut-out delay:
To prevent temperatures >100 °C in the plate heat exchanger after
the solar panel circulation pump switches off, for the Time
the parameters.
max" – 2 K) in this situation (e.g. by removal of hot water),
S
5
x
Operation
indicator flashes). In this case the
set in
PsA
zul".
K
zul"
K
29

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Solaris RPS3 P2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents