Removing The Sunroof - Dometic COOLAIR RT780 Installation Manual

CoolAir RT780, SP950T
SP950
No. in
fig. 5
bl
Blue
I
NOTE
After installing the unit, the specified parameters of the unit software must be
checked (chapter "Configuration of unit software" on page 15).
7.2

Removing the sunroof

Proceed as follows (fig. 6):
➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean and free
of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately. Observe the
local disposal guidelines.
EN
Designation
1 Condensate pump
2 Evaporator fan
3 Operating circuit board
4 Temperature sensor
5 Level sensor
6 Control unit
7 25 A fuse
8 4 A fuse vaporiser fan
9 4 A fuse condenser fan
10 Condenser fan
11 Compressor
12 Klickson (compressor)
br gl
Brown Yellow
gr ro
Green Red
Installation
sw w
Black White
11