Removing The Sunroof; Preparing The Unit Fastening; Preparing The Unit - Dometic CoolAir RT 780 Installation Manual

Installation
7.2

Removing the sunroof

➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
7.3

Preparing the unit fastening

➤ Enlarge the existing
a diameter of 8.5 mm (fig. 5 5, page 5).
7.4

Preparing the unit

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A
NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤ Screw in the 8 self-threading M8 thread inserts in the blind holes
marked with "1" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
16
6.5 mm drill holes for fastening the sunroof to
∅
CoolAir RT780
EN