Removing The Roof Hatch; Preparing The Unit Fixings - Dometic CoolAir RTX 1000 Installation Manual

CoolAir RTX1000, RTX2000
• The downward slope of the roof in forward direction in the area where the
unit is installed must not be more than:
– RTX1000: 8°
– RTX2000: 20°
• The assembly parts supplied must not be modified during installation.
• The ventilation openings must not be covered over (minimum distance from
other external attachments: 100 mm).
• Follow the vehicle manufacturer's guidelines when installing the system and
establishing the electrical connections.
According to the vehicle manufacturer's guidelines, the parking cooler must
be supplied using code E9G (pre-configured electrical equipment) or by
direct connection to the power distribution box behind the cab or direct
connection to the battery.
I
NOTE
After installation of the system, the pre-set parameters on the system software
must be checked (chapter "Configuring the system software" on page 12).
6.2

Removing the roof hatch

Proceed as follows (fig. 5):
➤ Remove all screws and fixings for the existing roof hatch.
➤ Take out the roof hatch.
➤ Remove the sealant around the opening so that the surface is clean and free
of grease.
I
NOTE
Dispose of all waste material, glue, silicon and seals separately. When doing
so, follow the waste disposal requirements applicable in your local area.
6.3

Preparing the unit fixings

➤ Drill out the 8 factory-made holes to a diameter of 10 mm (fig. 6).
EN
Installation
9