Menu Level 4: Default Setting; Menu Level 5: Temperature Unit Display - Dometic COOLAIR RT780 Installation Manual

Configuration of unit software
8.5

Menu level 4: Default setting

You can reset the parameters you set in configuration mode on menu levels 1 to
3 to the default settings:
➤ Start configuration mode (chapter "Starting and ending configuration mode"
on page 15).
✓ The first digit of the display shows the menu level and the second and third
show the parameter which can be set.
➤ Press the + button three times to switch to menu level 4.
✓ The display shows
➤ Press the
--
✓
flashes in the display.
➤ Press the + button.
✓ The display shows
➤ Press the
✓ The parameters set in configuration mode are reset to the default setting.
✓ You are now in menu level 4 and can use the + and – buttons to switch
between menu levels.
8.6

Menu level 5: Temperature unit display

The system can display the room temperature in °C or °F. This parameter can be
configured:
➤ Start configuration mode (chapter "Starting and ending configuration mode"
on page 15).
✓ The first digit of the display shows the menu level and the second and third
show the parameter which can be set.
➤ Press the + four times to switch to menu level 5.
➤ Press the
✓ The digits in the display flash until the parameter you entered is confirmed.
➤ Use the + and – buttons to select the temperature unit that the system should
display.
➤ Press the
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 5 again and can use the + and – buttons to switch
between menu levels.
18
--
.
button, to reset the unit to the factory settings.
00
.
button to confirm your entry.
button to change the parameters.
button to confirm your entry.
CoolAir RT780, SP950T
EN