Reference
Performance
Control Assign
From the Control Assign display you can make controller assign settings for the Part.
You can change sounds as desired by setting the desired controller to "Source" and the desired parameter
to "Destination." Not only physical controllers such as the Pitch Bend wheel but also Motion Sequencer or
Envelope Follower can be set to "Source" as a virtual controller.
Up to 16 Controller Sets can be assigned to each Part.
[PERFORMANCE (HOME)] [EDIT] Part selection Element [Common] [Mod/Control]
Operation
[Control Assign]
Auto Select (Auto Select Switch)
Determines whether the Auto Select function for Display Filter (below) is active (On) or not (Off). When this
parameter is set to "On," the operated Controller is automatically set in "Display Filter". Also you can obtain
the same result by pressing the [CONTROL ASSIGN] button.
Settings:
Off, On
Display Filter
Determines the Controller to be displayed. When "Super Knob" is selected, all Assignable Knob settings to
be affected by using the Super Knob are displayed.
Settings:
PitchBend, ModWheel, AfterTouch, FootCtrl 1, FootCtrl 2, FootSwitch, Ribbon, Breath, AsgnKnob 1–8, Super Knob,
AsgnSw 1, AsgnSw 2, MS Lane 1–4, EnvFollow 1–16, EnvFollowAD, EnvFollowMst, All
Display Name
Determines the name of each Assignable Knob 1–8 which is displayed in the Performance Play display
(page
27). This is available only when "AsgnKnob 1–8" is set in "Source."
MODX Reference Manual
Edit
Normal Part (AWM2)
Drum Part
Search
Utility
Normal Part (FM-X)
Live Set
Common/Audio
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Ins Assign
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
Copy or Exchange
Elements
100