Disk Control; 7-1: Copying Songs; 7-2: Deleting A Song - Yamaha DOM-30 Owner's Manual

DISK CONTROL
- Copying & Deleting Songs, Copying Disks —
The DOM-30 DISK CONTROL functions allow copying and delet-
ing songs, copying entire disks, and formatting new disks. The
DISK FORMAT operation has been described in detail in "Format-
ting a New Disk" on page 7. The remaining DISK CONTROL
functions are described below.
To select a DISK CONTROL function, hold down the FUNC-
TION button and press the DISK/8 button. A new DISK CON-
TROL function is selected each time the DISK/8 button is pressed.
SONG COPY
SONG DELETE
DISK COPY
DISK FORMAT
Disk
E) + O»
Copying Songs
Song data can "backed up" by copying to a new song number or
a different disk, as follows:
1. Select the SONG COPY Function
Hold down the FUNCTION button and press the DISK/8
button a few times until the SONG COPY display appears.
SONG COPY
2. Select the "Source" Song
When you release the FUNCTION button after selecting the
SONG COPY function, the following display will appear:
FROM 1 TO 1
Use the NO < and P YES buttons or number buttons to select
the number of the source song (i.e. the song which is to be
copied to a new song number or disk).
TRACK TEMPO VOICE VOLUME BEAT
opo
3. Select the "Target" Song Number.
After selecting the source song number, press the START/
STOP button and select the target song number" (the new song
number to which the source song is to be copied).
a
START/STOP
NO YES
FROM 2TO 10
* A target song number between 101 and 160 causes the copy to
be made to a different disk. For example, if you select "106" as
the target song number, the source song will be copied to song
number "6" on a different disk. When you START the copy
operation, the DOM-30 will tell you when to insert the "TARGET
DISK" (the disk to which the song is being copied) or the
"SOURCE DISK" (the disk from which the song is being copied)
as necessary. When copying to a new disk, make sure your
target disk has been properly formatted by the DOM-30, and that
its write protect tab is set to the write-enable position.
4. Start the Copy Operation
Press the START/STOP to actually begin the copy operation.
If you copy to a song number that already contains data, that
data will be overwritten by the new song data. To prevent
accidental erasure of previous material, the DOM-30 will ask
"ARE YOU SURE ?" if you have picked a target song number
that already contains data. Press the > YES button if you want
to go ahead with the copy operation, or the NO « button to
cancel.
o
START/STOP
> ARE YOU SURE ?
Noe YES
EE
Note: When copying to a different disk, the source and target disks
may have to be exchanged several times until the entire copy
is complete. Follow the DOM-30's "INSERT SOURCE!" and
"INSERT TARGET!" instructions until the entire song has
been copied.
Note: If you incorrectly insert the source or target disk, or insert a
completely different disk, the "CHANGE DISK!!" message
will appear prompting you to insert the correct disk.
Deleting a Song
You can delete any song from a loaded disk as follows:
1. Select the SONG DELETE Function
Hold down the FUNCTION button and press the DISK/8
button a few times until the SONG DELETE display appears.
SONG DELETE
2. Select the Song to Delete.
When you release the FUNCTION button after selecting the
SONG DELETE function, the following display will appear:
DELETE SONG ++
Use the NO d and P> YES buttons or number buttons to select
the song number you wish to delete.
NO 4 DYES
CAC)
3. Start the Delete Operation.
Press the START/STOP button to actually delete the selected
song. To prevent accidental erasure, the DOM-30 will ask
"ARE YOU SURE ?" at this point. Press the ® YES button
if you want to go ahead with the delete operation, or the NO
< button to cancel.