Ralink RT2880 User Manual page 86

Kernel/Library/Defaults Selection --->
[*] Customize Kernel Settings
Device Drivers --->
USB support --->
USB Network Adapters --->
<M> Multi-purpose USB Networking Framework
<M> ASIX AX88xxx Based USB 2.0 Ethernet Adapters
<M> CDC Ethernet support (smart devices such as cable modems)
CONFIG_USB_RTL8150=m
# insmod usbnet
# insmod cdc_ether
usbcore: registered new interface driver cdc_ether
# insmod asix.ko
usbcore: registered new interface driver asix
# usb 1-1: new high speed USB device using dwc_otg and address 2
usb 1-1: Product: USB2.0
usb 1-1: Manufacturer: ASIX Elec. Corp.
usb 1-1: SerialNumber: 01
usb 1-1: configuration #1 chosen from 1 choice
eth0: register 'asix' at usb-lm0-1, ASIX AX8817x USB 2.0 Ethernet, 00:0e:2e:41:72:9e
# brctl addif br0 eth0
device eth0 entered promiscuous mode
# brctl show br0
bridge name bridge id
br0 8000.000c43414367
# ifconfig eth0 up
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
br0: port 3(eth0) entering learning state
eth0: link up, 100Mbps, full-duplex, lpa 0xC5E1
br0: topology change detected, propagating
br0: port 3(eth0) entering forwarding state
RALINK AP SDK 3.3.0.0 User's Manual
STP enabled interfaces
no ra0
eth2.1
eth0
Page 86 of 93