Change Flash/Dram Size; Change Switch Controller In Rt2880 Platform - Ralink RT2880 User Manual

4M_16M_config.uclibc-2.4.x/4M_16M_config.uclibc-2.6.21.x
2M_16M_config.uclibc-2.4.x/2M_16M_config.uclibc-2.6.21.x
8M_16M_config.uclibc-2.4.x8M_16M_config.uclibc-2.6.21.x
d. Linux kernel 2.4/2.6 default configure file
2M_16M_config.linux-2.4.x/2M_16M_config.linux-2.6.21.x
4M_16M_config.linux-2.4.x/4M_16M_config.linux-2.6.21.x
8M_16M_config.linux-2.4.x/8M_16M_config.linux-2.6.21.x

9.2 Change Flash/DRAM Size

Change the DRAM size setting using "make menuconfig" if you increase or decrease the size
of DRAM.
#make menuconfig
Kernel/Library/Defaults Selection --->
[*] Customize Kernel Settings (NEW)
Machine selection --->
Linux 2.4
(RT2880-ASIC) RT2880 Chip Type
(32M) DRAM Size
(4M) Flash Size
Linux 2.6
System type (Ralink RT3052 board) --->
Soc Hardware Type (RT3052-ASIC) --->
DRAM Size (32M) --->
Root File System Type (RootFS_in_RAM) --->
9.3 Change Switch Controller in RT2880 Pl atform
The RT288x_SDK supports the IC+ 175C/D switch controller on the RT2880 platform at this time.
You can use 'make menuconfig' to adjust the switch controller settings.
RALINK AP SDK 3.3.0.0 User's Manual
Page 42 of 93