Update User/Kernel Default Settings - Ralink RT2880 User Manual

RALINK AP SDK 3.3.0.0 User's Manual
#make menuconfig
Kernel/Library/Defaults Selection --->
[*] Customize Kernel Settings
Network device support --->
Ralink Driver --->
W/LLLL in the LAN/WAN Partition item means P0 is a WAN port, and LLLL/W means P4 is WAN
Port. The switch is configured by the script, not the Ethernet driver. Please see config-vlan.sh in
RT288x_SDK/source/user/rt2880_app/ scripts.
Figure 6 IC+ 10/100 Switch Operation Diagram
9.4 Update User/Kernel defaul t settings
Modify the default setting if necessary. Select the 'Kernel/Library/Defaults Selection' item to
enter the kernel/application configuration menu. After entering the menu, select the 'Update
Default Vendor Settings' item to update the User/Kernel default settings. (Note: the new
default setting will be saved in
RT288x_SDK/source/vendors/Ralink/{RT2880/RT3052/RT3883}/config)
Page 43 of 93