Warming Up The Engine; Forward, Reverse, And Acceleration - TOHATSU MFS 2.5B Owner's Manual

28
ENGINE OPERATION
8. Set the control lever in the Neutral
position.
9. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it
quickly.
10. After engine starts, do not reinstall
7
flywheel cover and top cowl.
ENOM00043-B

3. Warming up the engine

ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check port dur-
ing warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
5°C (41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOF00222-0
CAUTION
-1
(rpm) : below
1
1. Cooling water check port
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 300 min
(rpm) for several minutes.
Clutch in (In gear)
-1
1200 min (rpm)
ENOM00046-B
4. Forward, reverse, and
acceleration
ENOW00037-0
WARNING
Before shifting into forward or reverse, make
sure that boat is properly moored and out-
board motor can be steered fully to the right
and left. Make sure that no swimmer(s) is
ahead or astern of the boat.
ENOW00038-A
WARNING
Attach other end of emergency stop
switch lanyard to the operator's PFD (Per-
ENOF00223-0
-1
Clutch off (Out of gear)
-1
1300 min (rpm)