TOHATSU MFS 2.5B Owner's Manual page 46

46
INSPECTION AND MAINTENANCE
1
1. Drain hole
4. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18N·m (13 ft·lb, 1.8 kgf·m)
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
5. Reset the engine in a vertical posi-
10
tion.
6. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
7. Remove the top cowl and the oil filler
cap.
8. Fill the engine through filler port with
recommended oil (see chart below)
to the middle of dipstick mark.
9. Tighten the oil filler cap.
1
1. Oil filler cap
2. Engine oil drain screw
3. Engine oil level gauge
ENOF01616-0
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
-30 -20
-22 -4
Oil volume needed for complete oil replacement
2
ENOF00245-0
10W−40
10W−30
-10 0 10 20 30
14 32 50 68 86
ENOF00208-0
300 mL (10 fl.oz.)
3
ENOF00244-0
40 ˚C
96 ˚F