TOHATSU MFS 2.5B Owner's Manual page 19

1. Bottom of hull
2. Anti ventilation plate
ENOW00007-0
CAUTION
Before beginning the running test, check
that the boat with maximum capacity
loading floats on the water in a proper
attitude. Check the position of water sur-
face on the driveshaft housing. If the
water surface is near the bottom cowling,
in high waves, water may enter the engine
cylinders.
Incorrect outboard
h e i g h t or e x i s t e n c e o f un d e r wa t e r
object(s), such as hull bottom design,
bottom surface conditions or underwater
accessories, can cause water spray possi-
bly reaching the engine through an open-
ing of the bottom cowling during cruising.
Exposing the engine to such conditions for
extended periods can lead to severe
engine damage.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENOM00830-A
Mounting bolts
Manual tilt type
1. To attach the outboard motor to the
boat, tighten the clamp screws by
turning their handles.
Secure the outboard motor with a
rope to prevent loss overboard.
1
30−50 mm
(1.2−2 in)
2
ENOF01608-0
motor mounting
ENON00002-0
Note
A rope is not included in the standard
accessories.
1. Clamp screw
ENOW00945-0
CAUTION
Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
Loosening may cause a dangerous situa-
tion, such as loss of control.
INSTALLATION
1
ENOF01626-0
19
5