Engine Operation; Before Starting; Fuel Feeding; Starting The Engine - TOHATSU MFS 2.5B Owner's Manual

Hide thumbs Also See for MFS 2.5B:
Table of Contents

Advertisement

24

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before star ting engine. ( To
properly fill the engine with oil follow the
instructions. See page 41)
7
ENOW00027-B
Before starting engine for the first time after
reassembling engine or off-season storage,
disconne ct stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM00044-D

1. Fuel feeding

ENOW00029-A
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
CAUTION
ENOF00240-0
CAUTION
WARNING
tank is raised by heat from sources such as
sun light.
1. Loosen the air vent screw on the tank
cap by two turns.
2. Open the fuel cock.
2
1. Air vent screw
2. Fuel cock
ENOW00937-0
CAUTION
Be sure to close the fuel cock when the out-
board motor is tilted up Otherwise, fuel
could overflow.
ENOM00045-C

2. Starting the engine

ENOW00036-A
CAUTION
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 48)
Run the engine only at idling.
1
ENOF00213-0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mfs 3.5b

Table of Contents