TOHATSU MFS 2.5B Owner's Manual page 53

ENON00021-1
Note
If the outboard motor must be laid
down be sure drain the fuel, then the
outboard motor on a cushion as
shown in the following drawing (See
page 53 and 35).
Elevate power unit 2 inches to 4 inches
if traveling to avoid oil spillage.
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause
the fuel to deteriorate during storage.
1. Before adding fuel stabilizer additive,
drain the carburetor (See page 53).
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
ENOF01613 0
If your motor is used occasionally, it is rec-
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container
full to reduce condensation and evapora-
tion.
ENOM00970-B
Fuel system draining
ENOW00028-A
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
ENOF01615-0
If fuel is spilled, wipe it up immediately.
Keep the fuel tank well away from sources
of ignition, e.g. sparks or open flames
Perform all work outdoors or in a well
ventilated place.
ENOW00097-0
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
d an c e w i t h l o c a l f ir e pr e v e n t i o n an d
environment protection regulations.
INSPECTION AND MAINTENANCE
WARNING
WARNING
53
10