Installing The Phone - RCA 21230 User Manual

Connections and Set Up

Installing the Phone

The phone may be connected to one 2-line (RJ14C) wall jack or two single line wall jacks.
12
1. Choose a level surface, such as a desktop or tabletop, near an
electrical outlet and a telephone wall jack (RJ11C) to install
your phone.
2. Plug the AC power converter into an electrical outlet and the
DC connector into the back of the base.
NOTE: The power converter must remain connected to the base at all
times. It is normal for the power converter to feel warm to the touch.
CAUTION: Use only the ATLINKS, Inc 5-2569 power converter
that came with this unit to charge the cordless handset. Using
other power converters may damage the unit.
3. Place the handset (with the battery pack installed) in the
base cradle. The charge indicator turns on to indicate the
battery is charging.
IMPORTANT: Make sure the cordless handset is facing forward during
charging.
4. Allow the handset to charge for 12 hours. If you don't
properly charge the cordless handset, battery performance is
compromised.
5. Connect the telephone lines: