System Reliability Guidelines; Handling Static-Sensitive Devices - IBM iDataPlex dx320 6385 User Manual

System reliability guidelines

To help ensure proper cooling and system reliability, make sure that the following
requirements are met:
v Each of the drive bays has a drive or a filler panel and electromagnetic
v The system-board tray battery is operational. If the battery becomes defective,
v You have replaced one or both system-board trays within 2 minutes of removal.
v The upper system-board tray is not operating with the bottom system-board tray
v The system-board tray cover is installed and closed.

Handling static-sensitive devices

Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the system-board
v Take additional care when you handle devices during cold weather. Heating
18
IBM iDataPlex dx320 User's Guide
compatibility (EMC) shield installed in it.
replace it immediately.
removed or powered off.
Static electricity can damage the server and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available.
metal surface on the outside of the chassis or rack for at least 2 seconds. This
drains static electricity from the package and from your body.
tray without setting down the device. If it is necessary to set down the device, put
it back into its static-protective package. Do not place the device on a metal
surface.
reduces indoor humidity and increases static electricity.