Table of Contents
Advertisement
Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in one of the following sections.
1. Install the system-board tray cover (see "Reinstalling the system-board tray
2. Install the system-board tray in the chassis (see "Reinstalling a system-board
3. Connect the cables. For more information, see "Connecting the cables" on page
4. For some devices, run the server BIOS Setup Utility program. For more
Reinstalling the system-board tray cover
Attention:
cover is installed and closed. Do not attempt to override this protection.
To reinstall the system-board tray cover, complete the following steps:
1. Lower the cover so that the pins at the rear slide down into the slots at the rear
2. Pivot the cover to the closed position until it clicks into place.
3. Install the system-board tray in the chassis (see "Reinstalling a system-board
26
IBM iDataPlex dx320 User's Guide
cover").
tray in a 2U chassis" on page 27).
28.
information, see "Updating the server configuration" on page 28.
You cannot install the system-board tray into the chassis until the
System-board
tray cover
of the system-board tray. Before you close the cover, make sure that all
components are installed and seated correctly, all internal cables are correctly
routed, and you have not left loose tools or parts inside the system-board tray.
tray in a 2U chassis" on page 27).
System-board
tray
Advertisement
Table of Contents
