Removing Dust From Filters - Hitachi PV-XEH900 Instruction Manual

Removing dust from filters

Clean filter
1
Open the filter cover
Set the dust case on the floor.
2
Remove dust from the clean filter
Detach the clean filter.
Clean filter
Perform maintenance (wash with water) when you are concerned about dirt or the suction power is weak. → (P.E-27)
3
Attach the clean filter.
Clean filter
4
Close the filter cover
Close the filter cover until you hear a "click" sound.
Filter cover
Clean lter
Dust case
Sponge
filter
Perform maintenance
(wash with water) when
you are concerned about
dirt of the sponge filter.
→ (P.E-27)
Open the filter cover while holding
the lower part of the lock cramp.
Remove attached dust by using the
maintenance brush.
Maintenance brush
Click
Filter cover
Lock cramp
Note
When removing
dust, do not slap the
clean filter onto the
floor, etc.
Doing so might
cause damage.
E-23