How To Charge - Hitachi PV-XEH900 Instruction Manual

How to charge

The battery is not sufficiently charged at the time of purchase. Please charge it before use.
(Charge time is approx. 3.5 hours.)
1
Insert the plug of the charging station into the socket.
Set the body on the charging station.
2
 The body cannot be set on the charging station while the extension pipe is attached. Remove the extension pipe.
Note
 If you set the body on the charging station, attach the dust case to the body.
 S horten the crevice brush. → (P.E-17)
 I nsert the charging station protrusion into the attachment groove of the body.
 T he battery indicator lamp turns on when the body is set on the charging station → (P.E-10)
 W hen fully charged, the battery indicator lamp turns off.
 Disconnect the plug from the socket when not using the cleaner for long periods of time.
 If you leave the body set on the charging station with the plug inserted in a socket for long periods of time
(a month or longer), the remaining battery level might be low. Lift the body once and set it on the charging station
again before use. Also, if the remaining battery level is low, the cleaner might automatically charge periodically.
 If you remove the body from the charging station while the battery indicator lamp is off (charging completed) and
then set it on the charging station again, the battery indicator lamp will turn on (charging in progress), which is
normal.
 The body or charging station might become hot while charging, which is normal.
 The body will not operate even if the control button is pressed while charging.
Note  If the battery indicator lamp does not turn on or if it immediately turns off, lift the body and set it on the
charging station again.
 When using for the first time, or when not used for a long time, the operating time be shorter and the
charging time may be longer.
 When charging the cleaner near a radio, the radio might be interrupted by noise or the radio program
might be difficult to hear.
When charging, place the charging station 2 m or more away from the radio and use separate sockets.
Plug
Socket
Hold the plug
Set the body on the charging station
while the body is propped up, and
insert the charging station
protrusion into the attachment
groove of the body.
Attachment
groove
Protrusion
Stand
Hold and pull the plug at the
end, not the cord.
Holding and pulling by the cord might damage
the power cord and cause a short circuit
resulting in an electrical shock or fire.
Battery indicator lamp Charging status
The battery is charging.
The temperature of the battery
changes depending on the usage
conditions, such as surrounding
On
temperature and operating time.
When the battery is hot, the cleaner will
automatically go into standby until the
temperature is suitable for charging,
which might prolong the charging time.
Charging is completed (fully charged).
Off
When charging is completed, it turns off.
CAUTION
E-11