RRU3642
Installation Guide
Step 2 Lay out the cable by referring to
ties.
Step 3 Label the installed cable by referring to Attaching an L-Shaped Label.
----End
7.13 Closing the Cover Plate of an RRU Cabling Cavity
This section describes the procedure for closing the cover plate of an RRU cabling cavity.
Procedure
Step 1 Close clips and tighten the screws on each clip to 1.4 N·m (12.39 lbf·in.) using a torque
screwdriver, as shown in
Figure 7-24 Closing clips
Ensure that the exposed shield layer of the power cable is properly tightened using the clip.
Step 2 Insert waterproof blocks into vacant cable troughs in the cabling cavity, as shown in
7-25.
Issue 01 (2011-12-27)
7.1 Cabling
Figure
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Requirements, and then bind the cable using cable
7-24.
7 Installing RRU Cables
Figure
82