Table of Contents
Advertisement
RRU3642
Installation Guide
2.
Step 6 Strip the specified length of the sheath off the power cable to expose the intact shield layer, as
shown in
Figure 10-8 Stripping the sheath off the power cable
Issue 01 (2011-12-27)
Figure 10-6 Tightening screws
Connect the blue core wire labeled NEG(-) to the - port and the black/brown core wire
labeled RTN(+) to the + port on the easy power receptacle (pressfit type) connector, and
then tighten the screws using a Phillips screwdriver, as shown in
Figure 10-7 Adding an easy power receptacle (pressfit type) connector to two core wires
Figure
10-8.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Appendix
Figure
10-7.
89
Advertisement
Table of Contents
